Tips on prolonging cell phone battery life

Prolong the Life of Your Cell Phone Battery -

Initialize a new cell phone battery. New batteries should be fully charged before their first use to obtain maximum capacity. Nickel-based batteries should be charged for 16 hours initially and run through 2-4 full charge/full discharge cycles, while lithium ion batteries should be charged for about 5-6 hours. Ignore the cell phone telling you that the battery is full--this is normal but is not accurate if the battery is not initialized.

Keep the cell phone battery cool. Your battery will last longest if used near room temperature, and nothing wears on a battery like extended exposure to high temperatures. While you can’t control the weather, you can avoid leaving your phone in a hot car or in direct sunlight, and you don’t have to carry your cell phone in your pocket, where your body heat will raise its temperature. In addition, check the cell phones battery while it’s charging. If it seems excessively hot, your charger may be malfunctioning.

Charge your cell phone battery correctly, in accordance with its type. Most newer cell phones have lithium-ion batteries, while older ones generally have nickel-based batteries. Read the label on the back of the battery or in the technical specifications in the wireless phone manual to determine which yours is.

Nickel-based batteries (either NiCd or NiMH) suffer from a phenomenon known as the "memory effect." If you charge the battery partially enough times, eventually the battery "forgets" that it can charge fully. A nickel-based battery suffering from memory effect can be reconditioned, which requires the battery to be completely discharged, then completely recharged (sometimes several times). The appropriate length of time between reconditionings varies. A good rule to follow for nickel-battery cell-phones is to discharge them completely once every two to three weeks, and only when you have a charger available.

Lithium ion batteries, on the other hand, do not suffer from the same memory effect. However, many devices that use lithium batteries have a battery meter, showing the user how much charge the battery has left. Starting with a battery's manufacture at the factory, lithium ions oxidize in the battery, shortening its life. After a certain amount of time, the battery exhibits slightly different electronic properties, which the device can only detect when the battery is discharged. This type of problem is known as a "virtual memory effect" and occurs when your battery meter can show a high charge, then suddenly drop to low charge when the battery is almost dead. Every thirty cumulative cycles, you should discharge lithium ion batteries until the phone gives a low battery warning, then recharge it. If you discharge lithium ion batteries to zero voltage, the internal safety circuit may open. In that case, a normal charger will be inadequate. Reconditioning ensures that the battery meter on a lithium ion cellphone is accurate (although it will not affect actual battery capacity).

Regardless of the cell phone battery type, use only a charger rated for your battery, and discontinue use of a charger that causes the battery to heat up excessively.

Store batteries properly. If your battery will be out of use for a while, disconnect it from the phone and store it in a cool place (the refrigerator is good, but freezing temperatures do not slow oxidation) and away from metal objects. Ensure that the battery is not exposed to moisture; try putting the battery in an airtight container or bag. Lithium ion batteries are not rated to operate at refrigerated temperatures, so let the battery sit outside the refrigerator for at least an hour before using it again. Lithium ion batteries oxidize least when they are stored at 40% charge. Never store a lithium battery at low voltage. Recharge batteries after storage.
Clean the battery contacts on the battery and on the phone. Over time, contacts may accumulate dirt. Clean them with a cotton swab and rubbing alcohol to maximize the efficiency of energy transfer. In addition, if the contacts are two different metals, such as gold and tin, accelerated corrosion known as "fretting" occurs. Cutting the corrosion from fretted contacts often requires solvents, such as acetone or nail polish remover. Be careful: these solvent dissolve plastic, so use a Q-Tip to avoid damaging the battery housing or the phone.

These tips on Better Cell Phone Battery Life come from Wikihow

Sphere: Related Content